Ingenico Lane/3000 - Configuring the Device Beep Settings

Ingenico Lane 3000 : Beep Settings Configuration

Article Contents: This article provides an introduction on how to inform you to adjust the beep settings on your Lane 3000 device.

Step-By-Step:

Step 1: Access the Admin Menu by pressing O (the green button) to select Settings.

Step 2: Press the down arrow to scroll to the Beep option, then press O (the green button) again to select it.

Step 3: Use the number pad to input a value for Frequency (Hz). Press the down arrow to navigate and enter values for Volume, Time On (ms), and Time Off (ms). Refer to the table below for default values and acceptable ranges:- Parameter Name: Frequency (Hz)
  - Default: 1,000
  - Range: 20-20,000
  - Description: Controls the pitch of the beep.- Parameter Name: Volume
  - Default: 100
  - Range: 1-100
  - Description: Controls the beep volume as a percentage.- Parameter Name: Time On (ms)
  - Default: 250
  - Range: 10-5,000
  - Description: Determines the duration of each beep.- **Parameter Name: Time Off (ms)
  - Default: 250
  - Range: 10-5,000
  - Description: Sets the pause length between beeps.

Step 4: Press O (the green button) to finalize your adjustments. The terminal will confirm the update by displaying "Beep parameters have been updated" and emit several beeps to demonstrate the new settings.

Note: To make permanent changes to your device's beep settings, note your desired settings and contact CardPointe Support.

    • Related Articles

    • Ingenico Lane 3000 : User Guide

      Article Contents: This article covers an overview of the Ingenico Lane 3000 User Guide. This Ingenico Lane 3000 User Guide covers the device's features, setup process, and troubleshooting. It explains how to connect the device, enter text using the ...

    • Ingenico Lane 3000 : Time Setting

      Article Contents: To adjust the date and time in the Lane 3000 settings you will need to navigate the admin menu for the device by following the below instructions. Step-By-Step: Step 1: Accessing and Navigating the Admin Menu. - The Admin Menu ...

    • Ingenico Lane 3000 : Device Disconnected

      Article Contents: This article covers the steps to follow if your Ingenico Lane 3000 device is displaying "Disconnected." Step-By-Step: Step 1: Verify that you are using the provided multi-point mono connector (Ethernet) cable and power supply. The ...

    • Ingenico Lane 3000 : Device Restarting Unexpectedly

      Article Contents: This article explains how to correct the issue of a device unexpectedly restarting during the day, which is commonly caused by inaccurate time settings. It provides a step-by-step guide to updating your time settings in CardPointe. ...

    • Ingenico Lane 3000 : Restarting the Device

      Article Contents: This article will instruct you on how to restart your Lane 3000 device. Step-By-Step: Step 1: You can restart your terminal using either of the following methods: To perform a soft reboot, Access the Admin Menu and select the ...